What to Do If Your JUUL Pod Has Water Damage

juul pod has water damage

After spending your hard-earned money for a Vape London, the last thing you need is a JUUL pod has water damage if you accidentally dropped it in a bathtub, sink, or a puddle.

What to do if juul pod has water damage?

  • Dissemble your Juul device
  • Dry the outside of your Juul device
  • Use Dry Rice or Silica Gel Sachets
  • Leave the Juul Device for 24 hours in a paper bag
  • Test Your JUUL Device 

London received a lot of rain recently in rainy season, and you might have gotten stuck on the roads because of all the floods. Some of the puddles still have not dried up, and you might risk dropping your device while walking if you are not careful because it is so small and can easily slip out of your pocket.

In case your device is waterlogged, here is what you can do to fix your pod and e-cigarette.

Dissemble Your Device

Even though you will void the replacement warranty for your London vape device, you need to take apart the JUUL. This can be done by separating the pod from your damaged equipment.

There are ways to dissemble more internal parts, but this is trickier and unnecessary for solving this specific problem.

Dry the Outside of Your Device

With a dry paper towel, gently dab and wipe off any water you see on your device. It is hard to tell exactly how much water has reached the inside of your JUUL Device. However, drying the outside will effectively stop more from entering.

Use Dry Rice or Silica Gel Sachets

Like drying a smartphone that got dropped in the toilet by accident, you can leave your London vape device for twenty-four hours in a paper bag, or in some loose dry rice. Usually, a spoonful of rice is enough because unlike your phone, the JUUL is approximately the size of a USB stick.

Make sure you use uncooked rice to avoid further problems. This will absorb excess moisture that is inside your device. Doing this at warm room temperatures will allow water from internal parts to evaporate into the air. The water that has evaporated will get absorbed by your silica gel sachet, or rice because they act as drying agents.

Test Your JUUL

After following these steps, you might be excited to go back to vaping in London again. Test out your JUUL and pod after letting it sit in the drying agent for the whole day. If the light doesn’t turn on, then you should leave your device or pod in the rice for a little longer.

If you take a hit and do not blow any vapour or notice a foul taste, then it might be time to change the pod because the water has unfortunately damaged it for good. Even though you might be very eager to have a London vape, you should never rush the drying process so that your JUUL can have plenty of rest to dry out.

Otherwise, this will cause more internal damage later if you do not let all the water evaporate before taking a hit.

Leave a Reply

Your email address will not be published. Required fields are marked *